Author Topic: Head and barrel Separation  (Read 2732 times)

Offline 4stroke

  • Advanced Member
  • ***
  • Posts: 4
  • Karma: +0/-0
    • View Profile
    • Email
Head and barrel Separation
« on: November 01, 2014, 08:32:09 AM »
Has anyone ever come across this before, after removing the engine of my T140 the last thing I expected was not being able to separate the head from the barrel, every nut and bolt has been removed and a half tin of Wd40 used including wooden wedges, in the end I removed them both still joined together in the vain hope I would be able to get better access , I have rebuilt many engines over the years but have never had this problem, a solution would be welcomed.

Offline mark2

  • Advanced Member
  • ***
  • Posts: 383
  • Karma: +2/-4
    • View Profile
Re: Head and barrel Separation
« Reply #1 on: November 01, 2014, 11:49:26 AM »
sounds like the alloy head has been crushed onto the stud thread (centre ones) . I would not use a wedge , turn the barrels upside down and with a wooden drift see if the head moves with a tap from inside , get another person to hold it off the floor

Offline john.k

  • Advanced Member
  • ***
  • Posts: 586
  • Karma: +4/-0
    • View Profile
    • Email
Re: Head and barrel Separation
« Reply #2 on: November 01, 2014, 12:41:45 PM »
You can also break the bond between the two by loosening the fasteners about 1 or 2 mm,and kicking the engine over  compression.Some gaskets [not solid copper Triumph though]develop a very strong bond,and driving in wedges will cause severe damage.Regards John.